SUBMITTED BY/EINGEREICHT VON: POLARMATIC OY

Innovation: Polarmoist –
aggregate ­moisture measurement sensor

Polarmoist is an outstanding optical moisture sensor designed for detecting moisture contained in concrete aggregates. The sensor embeds a micro-processor and uses LEDs as light sources. It is used to detect moisture in moving samples. Non-contact, remote measurement ensures stable performance and a long service life of the sensor.

Currently, the moisture measurement method most widely used in the concrete industry is based on capacitive or microwave sensors. Direct contact to samples causes mechanical wearing of the sensor, thus requiring occasional recalibration and finally replacement of the sensor. Optical measurement of material moisture permits non-contact detection with clear advantages for the concrete industry.

 

Performance

The figure on the left shows the results of a long-term test in a plant environment. Data was collected over a four-month period, leaving the optical sensor untouched during the entire test period. The weighed reference values were collected by typically taking three manual samples from a given mixing batch.

The apparent scatter in the data has clearly increased as compared to calibration data. However, the standard deviation, 0.25 % in moisture, is still fairly low. Surprisingly, the most significant reason for the scatter is not related to the performance of the optical sensor but instead to manual sampling problems of the weighed reference data.

The figure on the right shows an example of a sudden variation in aggregate moisture. Reference values and sensor readings revealed stable moisture rates of about 3.2 %. Suddenly, both readings started to increase to 5 % and above. This example shows why it is important to monitor aggregate moisture continuously instead of taking only one reference sample per day.

Polarmoist has been extensively tested in concrete plants with different grades of rock material. Appropriate calibration increases the accuracy of measuring water content compared to manual reference measurements in the case of a limited number of samples and a large variation of moisture in a given batch.

x

Related articles:

Issue 02/2017 Polarmatic Oy

Polarmoist – aggregate moisture ­measurement sensor

Polarmoist is an outstanding optical moisture sensor designed for detecting moisture contained in concrete aggregates. The sensor embeds a micro-processor and uses LEDs as light sources. It is used to...

more
Issue 10/2011 Practice report

Prototype application of photo-optical moisture sensors

The construction sector increasingly relies on the monitoring of the condition of buildings and structures. Both for new projects and existing buildings, the collection of building information is...

more
Issue 03/2023 HYDRONIX

Capturing and using moisture measurement data: ‘Big Moisture’

For many industries, such as precast concrete, measurement and control of the moisture in materials is vital. Whether it be getting the correct proportions of dry material, adding the incorrect amount...

more
Issue 10/2022 HYDRONIX

Moisture measurement – an essential for automating concrete production

The current worldwide health challenges are causing many organisations to adjust their working practices to minimise the staff involved in a site whilst still managing full production schedules....

more
Issue 09/2011 Sensors for all aggregates

Moisture sensor technology improves concrete quality

Moisture measurement of the various aggregates Normally just the moisture of the aggregate sand is measured if moisture measurement is carried out at all. But, if you look at the moisture distribution...

more